CHT-R5008 is a 5-10cm reading distance waterproof proximity card reader with Wiegand 26bits/ Wiegand34bits Standard Format and RS232 Optional Format Data Output. Can support 125khz and 13.56Mhz frequncy card.

It Possess the standard Wiegand 26BIT output format and extensive compatibility .This card reader not only can output the punching card No. to the main-control equipment but also can store related material contrast & card No. Information. The advantages are convenient installation, quick response to the card-punching. no card-punching failure. strong remove & protection to the quick pulse interrupt noise interruptstatic electricity & discharge electricity interrupt.

Model: CHT-R5018

Mifare Wiegand 26 Reader  
Mifare Wiegand 26 Reader  
Mifare Wiegand 26 ReaderSpecification:1).5-16 V Operating voltages
2).International Standards Wigand 26Bits.
3).More than 50mm Reading Range
4).All in One Antenna
5).Support EM-ID or Mifare Serial Number
6).External control Audio / Visual Indication: Internal LED and Buzzer
7).Optional Water-proof function for outside use. Installation

Using "+"type screw driver to loosen the screw between the panel and motherboard. And then embed the motherboard to the side wall with the plastic plug and screws.

Notice!
1. Confirm the electric voltage (DC12V) and differentiate positive anode and cathode of power supply
2. When external Power is used, make sure sharing the power with Controller Box or using the same GND
3. When the distance between card reader and controller is more than 50m, please use Power Line with at least 1.5 square cm Dia, or using several parallel Network wires.

Wire Connection：